Top Internet of Things Daily & Weekly

Connecting And Controlling The Stepper Motor In Motor Shield

Connecting And Controlling The #StepperMotor In #MotorShield via @CsharpCorner  #IoT

  • In this article, I will explain about connecting and controlling the Stepper motor in Motor Shield.
  • and I have set the rotation time of the Stepper motor.
  • The Arduino Motor Shield is used to connect full bridge drive to the circuit.
  • It is fully made up of 2 DC motors and includes load as the relay, and stepper motor solenoids.
  • It is also called an electronic device which produces the electrochemical cells.In the Stepper Motor, there are 5 pins and we have to connect 4 pins to the motor shield.

In this article, I will explain about connecting and controlling the Stepper Motor in Motor Shield.

@CsharpCorner: Connecting And Controlling The #StepperMotor In #MotorShield via @CsharpCorner #IoT

In this article, I will explain about connecting and controlling the Stepper motor in Motor Shield. It can be used to control the motor speed. and I have set the rotation time of the Stepper motor.

Stepper Motor is the DC motor so it moves in discrete steps. It can have many different sizes, speed controls, and positioning.

The Arduino Motor Shield is used to connect full bridge drive to the circuit. It is fully made up of 2 DC motors and includes load as the relay, and stepper motor solenoids. We can also measure the current of the motor.

The battery is used to give power to the circuit, so only the circuit will work. It is also called an electronic device which produces the electrochemical cells.

In the Stepper Motor, there are 5 pins and we have to connect 4 pins to the motor shield. We can leave the middle pin and connect all other 4 pins to the M3 and M4 while leaving the Gnd pin simply.

Connecting And Controlling The Stepper Motor In Motor Shield

Comments are closed, but trackbacks and pingbacks are open.